Application Guide

Heat Press Application Guide – DTF Transfers

Follow these steps to achieve the best results with your Direct-to-Film (DTF) transfers.

🔹 Supplies Needed

  • Heat press (recommended; not household irons)
  • Teflon sheet or parchment paper (for protection)
  • Garment of your choice (cotton, polyester, blends, etc.)

🔹 Application Instructions

  1. Set Your Heat Press
    • Temperature: 285–325°F (140–163°C)
    • Pressure: Medium to firm (40–60 psi)
    • Time: 10–15 seconds
  2. Pre-Press Garment
    • Place the garment on the heat press.
    • Pre-press for 2–5 seconds to remove moisture and wrinkles.
  3. Position Transfer
    • Place the DTF transfer face-down on the garment (design side touching fabric, film side on top).
    • Use heat-resistant tape if necessary to hold it in place.
  4. Press Transfer
    • Cover with a Teflon sheet or parchment paper.
    • Press at the set temp, time, and pressure.
  5. Peel Film
    • Depending on your transfer type:
      • Hot Peel: Peel immediately while warm.
      • Cold Peel: Allow transfer to fully cool before peeling.
  6. Final Press (Optional but Recommended)
    • Place parchment or Teflon sheet over design.
    • Press again for 3-8 seconds to lock in durability and finish.

🔹 Washing & Care Instructions

  • Turn garment inside out before washing.
  • Machine wash cold, gentle cycle.
  • Do not bleach.
  • Tumble dry low or hang dry.
  • Do not iron directly on the transfer.

⚠️ Important Notes

  • Always test on a sample garment before large production runs.
  • Heat press settings may vary slightly depending on your equipment and garment material.
  • We are not responsible for results due to improper application.
Scroll to Top